16 September, 2024

A Review Of Real 201 Exams

Proper study guides for Regenerate F5-Networks TMOS Administration certified begins with F5-Networks 201 preparation products which designed to deliver the Pinpoint 201 questions by making you pass the 201 test at your first time. Try the free 201 demo right now.

Page: 1 / 21

Total 254 questions Full Exam Access

Question 1

You have a pool of servers that need to be tested. All of the servers but one should be tested every 10 seconds, but one is slower and should only be tested every 20 seconds. How do you proceed?

It cannot be don

All monitors test every five seconds.

It can be done, but will require assigning monitors to each pool member.

It cannot be don

All of the members of a pool must be tested at the same frequency.

It can be done by assigning one monitor to the pool and a different monitor to the slower pool member.

Question 2

A development team needs to apply a software fix and troubleshoot one of its servers. The BIG-IP Administrator needs to immediately remove all connections from the BIG-IP system to the back end server. The BIG-IP Administrator checks the Virtual Server configuration and finds that a persistence profile is assigned to it. What should the 8IG-IP Administrator do to meet this requirement?

Set the pool member to a Forced Offline state and manually delete easting connections through the command line.

Set the pool member to a Forced Offline state.

Set the pool member to a Disabled state.

Set the pool member to a Disabled state and manually delete existing connections through the command line.

Question 3

The interface 1.1 of the BIG-IP device has been connected to a link dedicated to traffic on VLAN 120. What should the BIG-IP Administrator do to receive traffic from the VLAN?

Create a new VLAN object and set Customer Tag to 120

Create a new VLAN object and assign the interface 1.1 untagged

Create a new trunk object with interface 1.1 assigned

Create a new trunk object and assign it to the VLAN

Question 4

A site needs to terminate client HTTPS traffic at the BIG-IP and forward that traffic unencrypted. Which two are profile types that must be associated with such a virtual server? (Choose two.)

TCP

HTTP

HTTPS

ClientSSL

ServerSSL

Question 5

Assume the bigd daemon fails on the active system. Which three are possible results? (Choose three.)

The active system will restart the bigd daemon and continue in active mode.

The active system will restart the tmm daemon and continue in active mode.

The active system will reboot and the standby system will go into active mode.

The active system will failover and the standby system will go into active mode.

The active system will continue in active mode but gather member and node state information from the standby system.

Question 6

Refer to the exhibit
201 dumps exhibit

A connection is being established to IP 1.1.1.1 on port 8080. Which virtual server will handle the connection?

fwd_8080_vs

host_vs

host_ 8080_VS

fwdvs

Question 7

An LTM device has a virtual server mapped to www.f5.com with a pool assigned. Users report that when browsing, they are periodically required to re-login to /resources/201.1.7.b.2_l.com. The objects are defined as follows:
Virtual server. Destination 192.168.245.100:443 netmask 255.255.255.0 Persistence: SSL session persistence
Profiles: HTTP/TCP
Which persistence method should the BIG-IP Administrator apply to resolve this issue?

Source address affinity

hexadecimal

SIP

Destination address affinity

Question 8

A site has assigned the ICMP monitor to all nodes and a custom monitor, based on the HTTP template, to a pool of web servers. The HTTP based monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases?

All pool members are up since the HTTPbased monitor is successful.

All pool members are down since the ICMPbased monitor is failing in some cases.

The pool members whose nodes are failing the ICMPbased monitor will be marked disabled.

The pool members whose nodes are failing the ICMPbased monitor will be marked unavailable.

Question 9

Where is the loadbalancing mode specified?

within the pool definition

within the node definition

within the virtual server definition

within the pool member definition

Question 10

Which IP address will the client address be changed to when SNAT automap is specified within a Virtual Server configuration?

The floating self-IP address on the VLAN where the packet leaves the system.

The floating self-IP address on the VLAN where the packet arrives on the system.

It will alternate between the floating and non floating self-IP address on the VLAN where the packet leaves the system so that port exhaustion is avoided.

It will alternate between the floating and non floating self-IP address on the VLAN where the packet arrives on the system so that port exhaustion is avoided.

Question 11

Refer to the exhibit.
201 dumps exhibit

An LTM device has a virtual server mapped to www.f5.com. Users report that when they connect to
/resources/201.1.2h.l_l.com they are unable to receive content. What is the likely cause of the issue?

The pool associated with the virtual server does not have priority group activation enabled.

The virtual address does not have ARP enabled.

The virtual address does not have route advertising enabled.

The pool associated with the virtual server is falling its health check.

Question 12

A Virtual Server uses an iRule to send traffic to pool members depending on the URI. The BIG-IP Administrator needs to modify the pool member in the iRule.
Which event declaration does the BIG-IP Administrator need to change to accomplish this?

CLIENT_ACCEPTED

HTTP_RESPONSE

HTTP_REQUEST

SERVER_CONNECTED

Question 13

Refer to the exhibit
The BIG-IP Administrator is unable to access the management console via Self-IP 10.10 1.33 and port 443. What is the reason for this problem?

Packet Filter needs to be configured to allow a source

Self IP is configured to allow TCP All

Self IP is configured to allow UDP 443

Packet Filter is configured to allow port 443

Question 14

A virtual server is listening at 10.10.1.100:80 and has the following iRule associated with it:
when HTTP_REQUEST { if { [HTTP::header UserAgent] contains "MSIE" }
{ pool MSIE_pool }
else { pool Mozilla_pool }
If a user connects to http://10.10.1.100/foo.html and their browser does not specify a UserAgent, which pool will receive the request?

MSIE_pool

Mozilla_pool

Non

The request will be dropped.

Unknow

The pool cannot be determined from the information provided.

Question 15

A 816-IP Administrator recently deployed an application Users are experiencing slow performance with the application on some remote networks.
Which two modifications can the BIG-IP Administrator make to address this issue? (Choose two)

Apply dest addr profile to the Virtual Server

Apply f5-tcp-wan profile to the Virtual Server

Apply f5-tcp-lan profile to the Virtual Server

Apply source_addr profile to the Virtual Server

Apply fasti_4 profile to the Virtual Server

Question 16

A BIG-IP Administrator must determine if a Virtual Address is configured to fail over to the standby member of a device group in which area of the Configuration Utility can this be confirmed?

Device Management > Traffic Groups

Device Management > Devices

Local Traffic > Virtual Servers

Device Management > Overview

Question 17

Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are left at their defaults. If the origin server were to initiate traffic via the BIG-IP, what changes, if any, would take place when the BIG-IP processes such packets?

The BIG-IP would drop the request since the traffic didn’t arrive destined to the NAT address.

The source address would not change, but the destination address would be changed to the NAT address.

The source address would be changed to the NAT address and destination address would be left unchanged.

The source address would not change, but the destination address would be changed to a self-IP of the BIG-IP.

Page: 1 / 21

Total 254 questions Full Exam Access