16 October, 2019

Best Quality Cisco 200-125 Braindumps

Proper study guides for 200-125 CCNA Cisco Certified Network Associate CCNA (v3.0) certified begins with 125 200 preparation products which designed to deliver the 200 125 cisco by making you pass the 200-125 test at your first time. Try the free cisco 200 125 right now.

Free demo questions for Cisco 200-125 Exam Dumps Below:

Page: 1 / 64

Total 775 questions Full Exam Access

Question 1

- (Exam Topic 2)
You work as a network engineer for SASCOM Network Ltd company. On router HQ, a provider link has been enabled and you must configure an IPv6 default route on HQ and make sure that this route is advertised in IPv6 OSPF process. Also, you must troubleshoot another issue. The router HQ is not forming an IPv6 OSPF neighbor relationship with router BR.
Topology Details
Two routers HQ and BR are connected via serial links.
Router HQ has interface Ethernet0/1 connected to the provider cloud and interface Ethernet 0/0 connected to RA1
Router BR has interface Ethernet 0/0 connected to another router RA2.
IPv6 Routing Details
Ail routers are running IPv6 OSPF routing with process ID number 100 Refer to the topology diagram for information about the OSPF areas The Loopback 0 IPv4 address is the OSPF router ID on each router
Configuration requirements
• Configure IPv6 default route on router HQ with default gateway as 2001:DB8:B:B1B2::1.
• Verify by pinging provider test IPv6 address 2001 :DB8:0:1111:1 after configuring default route on HQ.
• Make sure that the default route is advertised in IPv6 OSPF on router HQ This default route should be advertised only when HQ has a default route in its routing table.
• Router HQ is not forming IPv6 OSPF neighbor with BR. You must troubleshoot and resolve this issue Special Note: To gain the maximum number of points, you must complete the necessary configurations and fix
IPv6 OSPF neighbor issue with router BR IPv6 OSPFv3 must be configured without using address families.
Do not change the IPv6 OSPF process ID.
200-125 dumps exhibit

Solution:
1- configure default route on router HQ : ipv6 unicast-routing ipv6 route ::/0 2001:DB8:B:B1B2::1
2- advertise this route under ospfv3
Ipv6 router ospf 100
Default-information originate
3- fix adjacency problem if a area mismatches We need to enter in s1/0
Ipv6 ospf 100 area 0

Does this meet the goal?

Yes

Question 2

- (Exam Topic 1)
Which statement about spanning-tree root-bridge election is true?

Every root bridge must reside on the same root switch

it is always performed automatically.

Every VLAN must use the same root bridge.

Each VLAN must have its own root bridge.

Question 3

- (Exam Topic 1)
Which value is used to determine the active router in an HSRP default configuration ?

router tracking number

router IP address

router priority

router loopback address

Question 4

- (Exam Topic 1)
200-125 dumps exhibit

refer to the exhibit , on R1, which routing protocol is in use on the route to 192.168.10.1?

EIGRP

OSPF

RIP

BGP

Question 5

- (Exam Topic 1)
Which WAN topology provides a direct connection from each site to all other sites on the network?

single-homed

full mesh

point-to-point

hub-and-spoke

Question 6

- (Exam Topic 2)
Which statement describes the effect of the exec-timeout 30 command?

The router maintains a user session indefinitely after it is active for 30 seconds.

The router disconnects the user session if it is inactive for 30 minutes.

The router maintains a user session indefinitely after it is active for 30 minutes.

The router disconnects a user session if it is inactive for 30 seconds.

Question 7

- (Exam Topic 5)
What is the effect of configuring a server farm on a switch that operates in VLAN 20 using isolated ports?

Hosts in the server farm are unable to communicate with each other.

The primary VLAN and hosts are able to communicate with hosts on other VLANs

The primary VLAN and hosts are able to reach community ports.

The primary VLAN and hosts are able to communicate with each other

Question 8

- (Exam Topic 2)
Refer to the exhibit.
200-125 dumps exhibit

The MAC address table is shown in its entirety. The Ethernet frame that is shown arrives at the switch. What two operations will the switch perform when it receives this frame? (Choose two.)

The switch will not forward a frame with this destination MAC address.

The frame will be forwarded out of all the ports on the switch.

The MAC address of ffff.ffff.ffff will be added to the MAC address table.

The frame will be forwarded out of all the active switch ports except for port fa0/0.

The MAC address of 0000.00aa.aaaa will be added to the MAC Address Table.

The frame will be forwarded out of fa0/0 and fa0/1 only.

Question 9

- (Exam Topic 3)
Which two statements about stateful firewalls in an enterprise network are true? (Choose two )

They can fitter HTTP and HTTPS traffic in the inbound direction only

They can use information about previous packets to make decisions about future packets.

They are most effective when placed in front of the router connected to the Internet

They are more susceptible to DoS attacks than stateless firewalls

They can track the number of active TCP connections

Question 10

- (Exam Topic 2)
Which two pieces of information can be shared with LLDP TLVs? (Choose two)

device management address

device type

spanning-tree topology

routing configuration

access-list configuration

Question 11

- (Exam Topic 3)
Which type of address is the public IP address of a NAT device?

outside global

outside local

inside global

inside local

outside public

inside public

Question 12

- (Exam Topic 3)
For which two reasons might you choose chassis aggregation instead of stacking switches? (Choose two)

to avoid the use of a centralized configuration manager

to increase the maximum port count

to increase the number of devices in use

to allow hot-swapping modules

to avoid relying solely on Ethernet interfaces

Question 13

- (Exam Topic 5)
Which effect of the copy tftp:flash: command is true?

It copies the startup configuration from a remote server to the local device.

It copies the system image from the local device to a remote server.

It copies the running configuration from the local device to a remote server.

It copies the system image from a remote server to the local device.

Question 14

- (Exam Topic 2)
Which two statements are true regarding ICMP packets? (Choose two.)

They are encapsulated within IP datagrams.

They guarantee datagram delivery.

TRACERT uses ICMP packets.

They acknowledge receipt of TCP segments.

They are encapsulated within UDP datagrams.

Question 15

- (Exam Topic 2)
Which two functions can be performed by a local DNS server? (Choose two)

transferring spirt horizon traffic between zones

Forwarding name resolution requests to an external DNS server

assigning IP addresses to local clients

resolving names locally

copying updatedIOS images to Cisco switches

Question 16

- (Exam Topic 2)
Refer to the exhibit.
200-125 dumps exhibit

You are configuring the router to provide Static NAT for the web server. Drag and drop the configuration commands from left onto the letters that correspond to its position in the configuration on the right.
200-125 dumps exhibit

Solution:
200-125 dumps exhibit

Does this meet the goal?

Yes

Question 17

- (Exam Topic 1)
Drag and drop each cable type from the left onto the type of connection for which it is best suited on the right .
200-125 dumps exhibit

Solution:
200-125 dumps exhibit

Does this meet the goal?

Yes

Question 18

- (Exam Topic 1)
Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)

to speed up convergence

to reduce routing overhead

to lower costs by replacing routers with distribution layer switches

to decrease latency by increasing bandwidth

to confine network instability to single areas of the network

to reduce the complexity of router configuration

Question 19

- (Exam Topic 5)
Which PPP subprotocol negotiates authentication options?

LCP

ISDN

DLCI

SLIP

NCP

Question 20

- (Exam Topic 3)
Which three are benefits of VLANs? (Choose three.)

They increase the size of collision domains.

They allow logical grouping of users by function.

They can enhance network security.

They increase the size of broadcast domains while decreasing the number of collision domains.

They increase the number of broadcast domains while decreasing the size of the broadcast domains.

They simplify switch administration.

Question 21

- (Exam Topic 5)
Which two results occur when the ipv6 enable command is entered? (Choose two)

An IPv6 EUI-64 interface ID is configured automatically on the interface.

IPv6 is enabled on a single interface.

An IPv6 link-local unicast address is configured automatically on the interface.

The administrator is prompted to configure an IP address on the interface

IPv6 is enabled globally on the device.

Question 22

- (Exam Topic 2)
Which two statements about access points are true? (Choose Two)

They can provide access within enterprises and to the public.

in Most cases, they are physically connected to other network devices to provide network connectivity.

They can proterct a network from internal and external threats.

Most access points provide Wi-Fi and Bluetooth connectivity.

They must be hardwired to a modem.

Question 23

- (Exam Topic 2)
Refer to the exhibit.
200-125 dumps exhibit

If the resume command is entered after the sequence that is shown in the exhibit, which router prompt will be displayed?

Router2#

Router2

Question 24

- (Exam Topic 3)
Which two statements are true for multicast MAC address directions?

01:00:5E:xx:xx:xx

one to one

01 00 xx xxxxxxx

02 xx xxxxxxx

one to many

Question 25

- (Exam Topic 3)
Refer to the exhibit.
200-125 dumps exhibit

A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?

This design will function as intended.

Spanning-tree will need to be used.

The router will not accept the addressing scheme.

The connection between switches should be a trunk.

The router interfaces must be encapsulated with the 802.1Q protocol.

Question 26

- (Exam Topic 4)
A switch is configured with all ports assigned to VLAN 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?

More collision domains will be created.

IP address utilization will be more efficient.

More bandwidth will be required than was needed previously.

An additional broadcast domain will be created.

Page: 1 / 64

Total 775 questions Full Exam Access