30 September, 2022

Free Fortinet NSE7_EFW-6.2 Free Dumps Online

It is more faster and easier to pass the Fortinet NSE7_EFW-6.2 exam by using Exact Fortinet Fortinet NSE 7 - Enterprise Firewall 6.2 questuins and answers. Immediate access to the Far out NSE7_EFW-6.2 Exam and find the same core area NSE7_EFW-6.2 questions with professionally verified answers, then PASS your exam with a high score now.

Check NSE7_EFW-6.2 free dumps before getting the full version:

Page: 1 / 7

Total 91 questions Full Exam Access

Question 1

View the IPS exit log, and then answer the question below.
# diagnose test application ipsmonitor 3 ipsengine exit log”
pid = 93 (cfg), duration = 5605322 (s) at Wed Apr 19 09:57:26 2017 code = 11, reason: manual
What is the status of IPS on this FortiGate?

IPS engine memory consumption has exceeded the model-specific predefined value.

IPS daemon experienced a crash.

There are communication problems between the IPS engine and the management database.

All IPS-related features have been disabled in FortiGate’s configuration.

Question 2

View the exhibit, which contains the partial output of an IKE real time debug, and then answer thequestion below.
NSE7_EFW-6.2 dumps exhibit

The administrator does not have access to the remote gateway. Based on the debug output, what configuration changes can the administrator make to the local gateway to resolve the phase 1 negotiation error?

Change phase 1encryption to AESCBC and authentication to SHA128.

Change phase 1 encryption to 3DES and authentication to CBC.

Change phase 1 encryption to AES128 and authentication to SHA512.

Change phase 1 encryption to 3DES and authentication to SHA256.

Question 3

A corporate network allows Internet Access to FSSO users only. The FSSO user student does not have Internet access after successfully logged into the Windows AD network. The output of the ‘diagnose debug authd fsso list’ command does not show student as an active FSSO user. Other FSSO users can access the Internet without problems. What should the administrator check? (Choose two.)

The user student must not be listed in the CA’s ignore user list.

The user student must belong to one or more of the monitored user groups.

The student workstation’s IP subnet must be listed in the CA’s trusted list.

At least one of the student’s user groups must be allowed by a FortiGate firewall policy.

Question 4

An administrator has configured a FortiGate device with two VDOMs: root and internal. The administrator has also created and inter-VDOM link that connects both VDOMs. The objective is to have each VDOM advertise some routes to the other VDOM via OSPF through the inter-VDOM link. What OSPF configuration settings must match in both VDOMs to have the OSPF adjacency successfully forming? (Choose three.)

Router ID.

OSPF interface area.

OSPF interface cost.

OSPF interface MTU.

Interface subnet mask.

Question 5

The logs in a FSSO collector agent (CA) are showing the following error: failed to connect to registry: PIKA1026 (192.168.12.232)
What can be the reason for this error?

The CA cannot resolve the name of the workstation.

The FortiGate cannot resolve the name of the workstation.

The remote registry service is not running in the workstation 192.168.12.232.

The CA cannot reach the FortiGate with the IP address 192.168.12.232.

Question 6

An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP. The output of thedebug flow is shown in the exhibit:
NSE7_EFW-6.2 dumps exhibit

Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)

HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.

Redirection of HTTP to HTTPS administrative access is disabled.

HTTP administrative access is configured with a port number different than 80.

The packet is denied because of reverse path forwarding check.

Question 7

Examine the output fromthe BGP real time debug shown in the exhibit, then the answer the question below:
NSE7_EFW-6.2 dumps exhibit

Which statements are true regarding the output in the exhibit? (Choose two.)

BGP peers have successfully interchangedOpenandKeepalivemessages.

Local BGP peer received a prefix for a default route.

The state of the remote BGP peer isOpenConfirm.

The state of the remote BGP peer will go toConnectafter it confirms the received prefixes.

Question 8

In which two states is a given session categorized as ephemeral? (Choose two.)

A TCP session waiting to complete the three-way handshake.

A TCP session waiting for FIN ACK.

A UDP session with packets sent and received.

A UDP session with only one packet received.

Question 9

An administrator has configured the following CLI script on FortiManager, which failed to apply any changes to the managed device afterbeing executed.
NSE7_EFW-6.2 dumps exhibit

Why didn’t the script make any changes to the managed device?

Commands that start with the # sign are not executed.

CLI scripts will add objects only if they are referenced by policies.

Incomplete commands are ignored in CLI scripts.

Static routes can only be added using TCL scripts.

Question 10

View the exhibit, which contains a partial web filter profile configuration, and then answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which action will FortiGate take ifa user attempts to access www.dropbox.com, which is categorized as File Sharing and Storage?

FortiGate will exempt the connection based on the Web Content Filter configuration.

FortiGate will block the connection based on the URL Filterconfiguration.

FortiGate will allow the connection based on the FortiGuard category based filter configuration.

FortiGate will block the connection as an invalid URL.

Question 11

View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question
below.
NSE7_EFW-6.2 dumps exhibit

Based on the debugoutput, which phase-1 setting is enabled in the configuration of this VPN?

auto-discovery-sender

auto-discovery-forwarder

auto-discovery-shortcut

auto-discovery-receiver

Question 12

View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below.
NSE7_EFW-6.2 dumps exhibit

The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic cannot pass through the tunnel. To diagnose, the administrator enters these CLI commands:
NSE7_EFW-6.2 dumps exhibit

However, the IKE real time debug does not show any output. Why?

The debug output shows phases 1 and 2 negotiations onl

Once the tunnel is up, it does not show any more output.

The log-filter setting was setincorrectl

The VPN’s traffic does not match this filter.

The debug shows only error message

If there is no output, then the tunnel is operating normally.

The debug output shows phase 1 negotiation onl

After that, the administrator must enable the following real time debug: diagnose debug application ipsec -1.

Question 13

Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which statement is true regarding the session in the exhibit?

It was created by the FortiGate kernel to allow push updates from FotiGuard.

It is for management traffic terminating at the FortiGate.

It is for traffic originated from the FortiGate.

Itwas created by a session helper or ALG.

Question 14

Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.

The TCP session for the BGP connection to 10.200.3.1 is down.

The local peer has received the BGP prefixed from the remote peer.

The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.

Question 15

Which real time debug should an administrator enable to troubleshoot RADIUSauthentication problems?

Diagnose debug application radius -1.

Diagnose debug application fnbamd -1.

Diagnose authd console –log enable.

Diagnose radius console –log enable.

Question 16

Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which statements are true regarding the above output? (Choose two.)

The port4 interface is connected to the OSPF backbone area.

The local FortiGate has been elected as theOSPF backup designated router.

There are at least 5 OSPF routers connected to the port4 network.

Two OSPF routers are down in the port4 network.

Question 17

An administrator has enabled HA session synchronization in a HA cluster with two members. Which flag is added to a primary unit’s session to indicate that it has been synchronized to the secondary unit?

redir.

dirty.

synced

nds.

Question 18

A FortiGate's portl is connected to a private network. Its port2 is connected to the Internet. Explicit web proxy is enabled in port1 and only explicit web proxy users can access the Internet. Web cache is NOT enabled. An internal web proxy user is downloading a file from the Internet via HTTP. Which statements are true regarding the two entries in the FortiGate session table related with this traffic? (Choose two.)

Both session have the local flag on.

The destination IP addresses of both sessions are IP addresses assigned to FortiGate'sinterfaces.

One session has the proxy flag on, the other one does not.

One of the sessions has the IPaddress of port2 as the source IP address.

Question 19

What global configuration setting changes the behavior for content-inspected traffic while FortiGate is in system conserve mode?

av-failopen

mem-failopen

utm-failopen

ips-failopen

Question 20

View the exhibit, which contains the output of a diagnose command, and the answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which statements are true regarding the Weight value?

Its initial value is calculated based on theround trip delay (RTT).

Its initial value is statically set to 10.

Its value is incremented with each packet lost.

It determines which FortiGuard server is used for license validation.

Question 21

View the exhibit, which contains a session entry, and then answer the question below.
NSE7_EFW-6.2 dumps exhibit

Which statement is correct regarding this session?

It is an ICMP session from 10.1.10.10 to 10.200.1.1.

It isan ICMP session from 10.1.10.10 to 10.200.5.1.

It is a TCP session in ESTABLISHED state from 10.1.10.10 to 10.200.5.1.

It is a TCP session in CLOSE_WAIT state from 10.1.10.10 to 10.200.1.1.

Page: 1 / 7

Total 91 questions Full Exam Access