16 October, 2019

Simulation Cisco 300-075 Dumps

Exam Code: 300-075 (300 075 ciptv2), Exam Name: Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2), Certification Provider: Cisco Certifitcation, Free Today! Guaranteed Training- Pass 300-075 Exam.

Cisco 300-075 Free Dumps Questions Online, Read and Test Now.

Page: 1 / 22

Total 269 questions Full Exam Access

Question 1

When considering Cisco Unified Communications Manager failover, how many backup servers can be
configured in a Cisco Unified Communications Manager Group?

Question 2

In a node-specific Service Advertisement Framework forwarder deployment model, what is the maximum number of Service Advertisement Framework forwarders that you can assign to a specific node?

Question 3

When configuring Cisco Unified Mobility, which parameter defines the access control for a call that
reaches out to a remote destination?

Calling Party Transformation Calling Search Space under Remote Destination Profile Information

User Local under Remote Destination Profile Information

Rerouting Calling Search Space under Remote Destination Profile Information

Rerouting Calling Search Space under Remote Destination information

Calling Search Space under Phone Configuration

Question 4

Which configuration can you add to Mobile Connect to explicitly allow or block calls to remote
destinations based on the caller ID of the caller?

access list

route filter

external call control

call anchoring

Question 5

An engineer is performing an international multisite deployment and wants to create an effective backup method to access TEHO destinations in case the call limit triggers. Which technology provides this ability?

AAR

CFUR

LRG

SRST

Question 6

Which two statements regarding IPv4 Static NAT address 209.165.200.230 has been configured on a
VCS Expressway are true? (Choose two.)

The Advanced Networking or Dual Network Interfaces option key has been installed.

VCS rewrites the Layer 3 source address of outbound SIP and H.323 packets to 209.165.200.230.

VCS applies 209.165.200.230 to outbound SIP and H.323 payload messages.

With static NAT enabled on the LAN2 interface, VCS applies 209.165.200.230 to outbound H.323 and SIP payload traffic exiting the LAN1 interface.

Question 7

The administrator at Company X is getting user reports of inconsistent quality on video calls between
endpoints registered to Cisco Unified Communications Manager. The administrator runs a wire trace while a video call is taking place and sees that the packets are not set to AF41 for desktop video as they should be.
Where should the administrator look next to confirm that the correct DSCP markings are being set?

on the MGCP router at the edge of both networks

the service parameters in the VCS Control

the QoS service parameter in Cisco Unified Communications Manager

on the actual Cisco phone itself because the DSCP setting is not part of its configuration file downloaded at registration

The setting cannot be changed for video endpoints that are registered to Cisco Unified Communications Manager, but only when they are registered to the VCS Control.

Question 8

Company X has three locations connected via a low bandwidth WAN. Which two configurations are
required in the Cisco Unified Communications Manager region to provide the most suitable use of bandwidth while preserving the call quality? (Choose two)

g722/g711 for interregion calling

g722/g7l1 codec for all calling

g729 codec for all calling

g729 codec for intraregion calling

g722/g711 codec for interregion calling

g729 codec for interregion calling

Question 9

Which feature allows you to specify which endpoints ring when someone calls a user on a specific
destination ID?

FindME

Extension Mobility

Speech Connect

Single Number Reach

Question 10

What is an advantage of TEHO?

TEHO implemented with ISRs eliminates PSTN toll charges.

TEHO implemented with ISRs can reduce PSTN toll charges.

TEHO implemented with AAR reduces toll charges.

TEHO implemented with CFUR reroutes calls.

Question 11

Which three options are overlapping parameters for roaming when a device is configured for Device Mobility? (Choose three.)

device pool

location

network locale

codec

MRGL

extension

Question 12

Which option describes the meaning of a call termination cause code of 1 in a Cisco Unified
Communications?

normal call cleaning

resource unavailable, unspecified

call rejected

Unallocated (unassigned) number

Question 13

Which two roaming sensitive setting in the device pool configuration window override the device
level settings when the device roams within or outside a of device mobility group? Choose two

MRGL

codec

device pool

network locale

extension

Question 14

When configuring Cisco Unified Survivable Remote Site Telephony, which CLI command enables this feature on the router?

call-manager-fallback

ccm-manager redundant-host

ccm-manager sccp local

ccm-manager switchback

Question 15

Which two commands verify Cisco IP Phone registration? (Choose two.)

show telephony-service ephone-dn

show voice register session-server

show ephone registered

show ccm-manager hosts

show sip-ua status registrar

Question 16

Which three commands are mandatory to implement SRST for five Cisco IP Phones? (Choose three.)

call-manager-fallback

max-ephones

keepalive

limit-dn

ip source-address

Question 17

An engineer must resolve a call failure issue. When using RTMT, the engineer notices that the
Location Bandwidth Manager-OutOfResources counter is showing a positive value. Which option is the cause of the call failure?

lack of audio bandwidth

lack of video bandwidth

lack of transcoding resources

lack of audio or video bandwidth

lack of conferencing resources

Question 18

Which configuration for the IP DSCP value in the ToS byte to 5 with Expedited Forwarding is correct?

policy-map policy1 class class1set ip dscp 5 class class2set ip dscp C S3

policy-map policy1 class class1set ip dscp ef class class2 set ip dscp 5

policy-map policy1 class class1set ip dscp 5 class class2 set ip dscp ef

policy-map policy1class class1 set ip dscp 3 class class2 set ip dscp ef

Question 19

Company X has deployed a VCS Control with a local zone and a traversal client zone. To facilitate external calls, VCS Expressway is deployed and traversal server zone is set up there. Video endpoints inside Company X have registered, but are unable to receive calls from outside endpoints. Which option could be the cause of this issue?

The traversal zone on the VCS Control does not have a search rule configured.

The access control list on the VCS Control must be updated with the IP for the external users.

When a traversal zone is set up on VCS Control only outbound calls are possible.

The local zone on the VCS Control does not have a search rule configured.

Question 20

Scenario:
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone.
The Cisco VCS and TMS control the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
DP:
300-075 dumps exhibit

Locations:
300-075 dumps exhibit

CSS:

SRST:

SRST-BR2-Config:
300-075 dumps exhibit

BR2 Config:
300-075 dumps exhibit

SRSTPSTNCall:
300-075 dumps exhibit

After configuring the CFUR for the directory number that is applied to BR2 phone ( 442288224001),
the calls fail from the PSTN. Which two of the following configurations if applied to the router, would remedy this situation? (Choose two.)

dial-peer voice 1 potsincoming called-number 228822… direct-inward-dialport 0/0/0:15

dial-peer voice 1 potsincoming called-number 228822… direct-inward-dialport 0/0/0:13

voice translation-rule 1 rule 1/˄228821....S// 44

Question 21

Which feature enables users to manage business calls by using one phone number to pick up in-progress calls on either their desk phone or their mobile phone?

desktop call pickup

send call to mobile phone

mobile connect

mobile voice access

access list

Question 22

Where do you go to configure restrictions on audio bandwidth?

location

partition

region

enterprise parameters

serviceability

Question 23

Which option is a valid test scenario to verify that Cisco Unified Communications Manager failover
works and endpoints register with the backup call manager?

During a predetermined maintenance window, stop the Cisco IP Phone Services service on the primary Unified C

Devices should reregister with the backup Unified CM in the Cisco CallManager Group.

During a predetermined maintenance window, stop the Unified CM service on the Publishe

Devices should reregister with the backup Publisher in the Cisco CallManager Group.

During a predetermined maintenance window, stop the TFTP service on the primary call manage

Devices should reregister with the backup Unified CM in the Cisco CallManager Group.

During a predetermined maintenance window, stop the Unified CM service on the primary call manage

Devices should reregister with the backup Unified CM in the CallManager Group.

Question 24

An engineer opens up a TAC case and wants to implement CCD/SAF service. Which menu navigation
sequence must an engineer navigate to when configuring a hosted DN pattern?

Call Routing

Question 25

An administrator is visiting a remote site that has on-net calls with headquarters and one voice gateway for PSTN calls. When using RTMT to monitor the bandwidth utilization of the remote site, the administrator notices the OutOfResources counter for the site in LBM has been increasing slowly in last two weeks, but no call failure reports have been sent from this site. Which description about this issue is true?

The bandwidth settings of the site are fulfilling on-net call volume.

AAR is routing some of the calls.

The location-based CAC does not work properly.

The LBM service is malfunctioning.

Question 26

Which functionality does ILS use to link all hub clusters in an ILS network?

Fullmesh

Automesh

ILS updates

multicast

Page: 1 / 22

Total 269 questions Full Exam Access