29 February, 2020

Supporting Cisco Routing And Switching Network Devices 640-692 Resource

Ucertify 640-692 Questions are updated and all 640-692 answers are verified by experts. Once you have completely prepared with our 640-692 exam prep kits you will be ready for the real 640-692 exam without a problem. We have Most recent Cisco 640-692 dumps study guide. PASSED 640-692 First attempt! Here What I Did.

Online 640-692 free questions and answers of New Version:

Page: 1 / 7

Total 92 questions Full Exam Access

Question 1

Which of the following best describes the cable that is used to connect a laptop to an Ethernet port on a Cisco router?

Crossover

Straight-through

Fiber

Rollover

Question 2

Which windows-based text editor is preferred when working with a simple text document such as a Cisco configuration?

Microsoft Excel

Microsoft Word

Microsoft Notepad

Microsoft Access

Question 3

Which two commands display the saved configuration file? (Choose two)

show configuration

show file system

show running-config

show startup-config

Question 4

Which two of the following are component of WAN connection? (Choose two)

router

switch

CSU/DSU

Hub

Bridge

Question 5

Which two pairs of LAN Ethernet devices use an RJ-45 Straight-through cable? (Choose two)

Switch to switch

Switch to router

Switch to server

Router to router

Switch to hub

Question 6

How does a Cisco switch respond if you boot it without a valid configuration in the NVRAM?

it enters setup mode.

it uses the running –configuration

It prompts you to restore the startup configuration

it enters user EXEC mode.

Question 7

Refer to the exhibit.
640-692 dumps exhibit

Which type of cable us used on the ATM card?

Fiber-optic BNC

Coaxial

Serial

Crossover

Question 8

Which IOS layer does a server use to keep track of which application communications in which conversation?

Transport

Network

Session

Application

Question 9

What are two possible causes if an Ethernet interface is up and the line protocol is down? (Choose two)

The Ethernet cable might not be attached properly

There is a speed or duplex mismatch with the remote device

The Ethernet interface has been manually disabled

There is a Layer 2 mismatch in the encapsulation type

Keepalives are not being received by the local device

Question 10

TFTP is a simple protocol files, such as a Cisco IOS or configuration file, from one device to another. Which device cannot be configured to be used as a TFTP server?

Cisco router

Cisco switch

Computer

Modem

Cisco wireless LAN

Question 11

When using a modem to provide out-of-band access to a Cisco router, which cable type is used to connect the wall jack to the modem?

DB-25 to RJ-11

RJ-11 to Rj-11

RJ-45 to RJ-45

RJ-11 to RJ-45

RJ-11 to DB-9

Question 12

Which address facilitates the routing of packets over an IP network?

MAC

transport

network

physical

Question 13

DRAG DROP

Solution:
The correct answer is: Router(boot)# Router(config-if)# Router(config)# Router#
Rommon> Router>

Does this meet the goal?

Yes

Question 14

Which two commands are used to set the configuration register value? (Choose two)

Router(config)#config-register 0x2102

Router(config)#confreg 0x2102

rommon>config-register 0x2102

rommon>confreg 0x2102

Router(config)#configuration-register 0x2102

Question 15

From a Windows command prompt, which command displays the local IP address of a computer?

ip config

ip configuration

ipconfig

ipconfiguration

Question 16

Which command indicates the amount of memory (NVRAM, RAM, and flash) in a Cisco device?

show diag

show environment

show inventory

show version

Question 17

Which two of the following are true? (Choose two)

Telnet is preferred over SSH for security reasons.

SSH is a protocol that provides a secure remote access connection to network devices.

When using HyperTerminal to communicate over a TCP/IP network, the SSH protocol is used.

A Telnet network management connection is dropped when a router reboots.

Telnet is a protocol that provides a secure remote access connection to network devices.

Question 18

Which three pieces of information about a device can be seen from the show version command? (Choose three)

CPU load

Device model

Installed DRAM

Installed flash

Locally configured IP addresses

Question 19

On which three operating systems does HyperTerminal not come pre-installed? (Choose three)

Windows XP

Windows Vista

Mac OSX

Windows 98

Windows 7

Windows 2000

Question 20

Refer to the exhibit.
640-692 dumps exhibit

For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)

Router1 has specific boot system commands that instruct it to load IOS from a TFTP server.

Router1 is acting as a TFTP server for other routers.

Router1 cannot locate a valid IOS image in flash memory.

Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.

Cisco routers will first attempt to load an image from TFTP for management purposes.

Question 21

Which bits represent the boot field in the configuration register value?

highest two bits

highest four bits

lowest two bits

lowest four bits

Question 22

Which statement describes the effect of the copy run start command on a router in enable mode?

The running configuration of the router is saved to NVRAM and used during the boot process.

The router reboots and loads the last saved running configuration.

A copy of the running configuration of the router is sent by FTP to a designated server.

A new running configuration is loaded from flash memory to the router.

Question 23

What are two ways to open Microsoft Notepad on a Windows-based computer? (Choose two)

Start > Run Enter Notepad and \'Ink OK

Start > Control Panel > Notepad

Start > All Programs > Notepad

Start > All Programs > Accessories > Notepad

Start > All Programs > Microsoft Office > Notepad

Question 24

Which three of the following statements are true about a router? (Choose three)

It forwards broadcast frames.

It interconnects multiple networks together.

It chooses the best route for your data to travel.

It manages and analyzes a company\'s database.

It divides a network into separate broadcast domains.

Question 25

Which two pieces of information can be determined about a neighbor device from the CLI command show cdp neighbor? (Choose two)

device ID

IP address

platform

uptime

Page: 1 / 7

Total 92 questions Full Exam Access