26 March, 2024

The Secret Of ISQI CTFL_Syll2018 Training Materials

It is impossible to pass iSQI CTFL_Syll2018 exam without any help in the short term. Come to Examcollection soon and find the most advanced, correct and guaranteed iSQI CTFL_Syll2018 practice questions. You will get a surprising result by our Far out ISTQB Certified Tester Foundation Level (Syllabus 2018) practice guides.

Free demo questions for iSQI CTFL_Syll2018 Exam Dumps Below:

Page: 1 / 16

Total 196 questions Full Exam Access

Question 1

- (Exam Topic 2)
A test case starts at S1 and triggers 4 events in sequence: E1, E4, E5, E7. What will be the finishing state and the output(s) from the test case? [K3]
Refer to the exhibit
CTFL_Syll2018 dumps exhibit

S2 and O4

S4 and O2

S4 and O4

S2 and O2

Question 2

- (Exam Topic 3)
Tests have been specified for the latest software release and users have prioritised these.
However, there are some dependencies between tests as shown in the table below (e.g. Test ID. ‘123’ cannot be run until Test ID. ‘456’ has been successfully completed).
CTFL_Syll2018 dumps exhibit

Which test execution schedule best meets the prioritisation and dependency conditions?

3, 5, 7, 10, 2, 4, 6, 8, 9, 1.

5, 7, 4, 3, 9, 10, 1, 6, 8, 2.

6, 1, 2, 9, 4, 3, 5, 7, 8, 10.

1, 4, 3, 5, 2, 7, 9, 10, 6, 8.

Question 3

- (Exam Topic 3) The following condition is given: Integer x, y; IFx>0ANDx< 100
y = y + x; END-IF
Using boundary analysis for x. which test cases are required?

-1,0.1,99.100, 101

-1,0. 100,101

-500,-10,0.1,99.100.101,500

0, 1.99, 100

Question 4

- (Exam Topic 3)
Which of the following statements regarding incidents is NOT true?

Incidents should be tracked from discovery and classification to correction and confirmation of the solution.

The discrepancies between actual and expected outcomes need to be logged as incidents

Since incidents are the discrepancies between actual and expected outcomes they cannot be raised during development

Incidents may be raised during development, review, testing or use of a software product

Question 5

- (Exam Topic 3)
Agile development can be classified as which life cycle model?

Agile development is not related to any life cycle model

RAD

V model

Iterative Incremental .

Question 6

- (Exam Topic 3)
Which of the following apply to System Testing?
a) May satisfy legal requirements.
b) Can use system specifications as a test basis.
c) Often the responsibility of business users.
d) Main goal is to establish confidence.
e) Should focus on the communication between systems.

a and c.

b and d.

a and b.

c and e.

Question 7

- (Exam Topic 1)
Which of the following is an example of black-box dynamic testing?

Code inspection

Checking memory leaks for a program by executing it

Functional Testing

Coverage analysis

Question 8

- (Exam Topic 3)
Which of the following statements is the best explanation why software failures can be caused by environmental conditions?

Factors like magnetism, radiation and even pollution can affect electronic devices and the performance of their embedded real time software

Environmental conditions only affect the hardware - not the software

If the hardware on which the software application is running under ambient temperature and humidity, no failures can be linked to environmental conditions

Extreme heat and vibrations exerted on storage media can cause errors in algorithms and program flows

Question 9

- (Exam Topic 3)
Which of the following sentences about testing and debugging is correct?

Re-testing checks that debugging has found and analyzed the failure

Dynamic testing finds defects, while debugging removes failures

Dynamic testing reveals failures, while debugging removes defects

Like most development activities, debugging is usually done before testing starts

Question 10

- (Exam Topic 3)
Which of the following statements correctly describe Black-Box Testing''

Test on an individual software component in isolation from other components, to avoid external influence

Tests that investigate the input v

trfe output behavior of a software system.

Test derived from the ability of the testers and their intuition and experience with similar applications and technologies (sometimes used to strengthen systematic techniques)

Test of the interfaces between components and of the interactions with different parts of a system

Question 11

- (Exam Topic 3)
Consider the following pseudo-code
CTFL_Syll2018 dumps exhibit

How many minimum test cases are required to cover 100% Statement coverage and Decision coverage?

5 for Statement, 5 for Decision

4 for Statement, 5 for Decision

8 for Statement, 6 for Decision

6 for Statement, 8 for Decision

Question 12

- (Exam Topic 2)
Which of the following are 'Exit Criteria?'

Acceptance criteria, completion criteria, pass/fail criteria.

Coverage of code, schedule, estimates of defect density.

The last executable statement within a component.

Cost overruns.

Question 13

- (Exam Topic 3)
Which of the following is a typical characteristic of the WALKTHROUGH review type?

The meeting is led by the author.

Metrics are gathered throughout.

Attendees must prepare before the meeting.

Entry and exit criteria are defined.

Question 14

- (Exam Topic 2)
What are metrics NOT used for?

To identify the percentage of work done in test environment preparation.

To identify the percentage of work done in test case preparation.

To apply to the RAD development model.

To measure whether dates of test milestones were met.

Question 15

- (Exam Topic 3)
Which of the following statements is true?

Regression testing is a technique for system testing and acceptance testing only.

Regression testing can be used in any level of testing, but must be done after white-box testing has been finished.

Regression testing is an alternative term for re-testing

Regression testing is intended to find side-effects after changes have been applied to the system under test.

Question 16

- (Exam Topic 3)
Which of the following BEST describes how configuration management supports the test process?

It enables the tester to reproduce the tested item through unique identification and version control.

It enables the tester to systematically design test conditions, cases and data.

It enables incidents to be tracked from discovery and classification to correction and confirmation of the solution.

It helps the test manager to decide how best to integrate and coordinate the testing activities into the software life cycle.

Question 17

- (Exam Topic 2)
An iPhone application identifies and counts all purchases of a particular product from a shopping website. The application incorrectly counts purchase attempts by including both failed attempts, and also those where the purchase was terminated by the user before completion. Testing has identified that the problem was located in the ‘purchase identification’ module, where the first stage in the purchasing process was counted, rather than a successful confirmed purchase.
Which of the following statements correctly identifies what has happened? [K2]

The application failed because of a defect in the purchase identification module caused by a programmer mistake or an error in the specification.

An error by the programmer led to a mistake in the purchase identification module and this caused a defect in the application

A defect in the purchase identification module caused by a mistake in the module specification led to a defect in the overall application

A bug in the purchase identification module caused a fault in the application

Question 18

- (Exam Topic 3)
A QA manager of a start-up company needs to implement within a week a low cost incident management tool Which of the following is the best option?

Manage the incidents through E-mails and phone calls

Manage the incidents in a spreadsheet posted on the intranet

Purchase and deploy an incident management tool

Document incidents on a large board in the lab

Question 19

- (Exam Topic 2)
Which of the following is a white box testing design characteristic?

To be based on specifications

To be based on an analysis of the test basis documentation

To be based on an analysis of the structure of the component or system

To include both functional and non-functional testing

Question 20

- (Exam Topic 3)
A software system checks age in order to determine which welcome screen to display Age groups are
Group I: 0-12
Group II: 13-18 Group III: over 18
Which of the below represent boundary values?

(0, 12, 13,18,19)

(-1,0,11,12,13,14,18,19)

(4,5,15,20)

(-1.0,12,13,18,19)

Question 21

- (Exam Topic 3)
Which of the following would achieve the HIGHEST level of testing independence for a project's test level?

Training developers to design good tests for the test team to execute

Outsourcing test design and execution to a different company

Having the company's independent test team design and execute the tests

Minimising contact between testers and developers during test design to avoid bias

Question 22

- (Exam Topic 3)
Which of the following are product risks?
a) Failure prone software delivered.
b) Software does not perform its intended functions.
c) Insufficient staff available for testing.
d) Test environment not ready on time.
e) Poor data integrity and quality.

b, c and e.

b, d and e.

a, b and e.

b, c and d.

Question 23

- (Exam Topic 1)
Which ONE of the following statements does NOT describe how testing contributes to higher quality?

Performing a review of the requirement specifications before implementing the system can enhance quality

The testing of software demonstrates the absence of defects

Properly designed tests that pass reduce the level of risk in a system

Software testing identifies defects, which can be used to improve development activities.

Question 24

- (Exam Topic 3)
What of the following statements regarding walkthrough are NOT true?

A walkthrough is lead by a moderator and requires pre-meeting preparation and post meeting follow up

A walkthrough may take the form of scenarios, dry runs and peer group review

The purpose of a walkthrough is to establish common understanding of a document and to find possible defects in it

Pre-meeting preparation, documentation and distribution of results are optional for a walkthrough

Page: 1 / 16

Total 196 questions Full Exam Access