01 July, 2021

Top Tips Of Far Out 300-410 Free Exam Questions

Cause all that matters here is passing the Cisco 300-410 exam. Cause all that you need is a high score of 300-410 Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) exam. The only one thing you need to do is downloading Certleader 300-410 exam study guides now. We will not let you down with our money-back guarantee.

Check 300-410 free dumps before getting the full version:

Page: 1 / 4

Total 58 questions Full Exam Access

Question 1

While working with software images, an engineer observes that Cisco DNA Center cannot upload its software image directly from the device. Why is the image not uploading?

The device must be resynced to Cisco DNA Center.

The software image for the device is in install mode.

The device has lost connectivity to Cisco DNA Center.

The software image for the device is in bundle mode

Question 2

Refer to the exhibit.
300-410 dumps exhibit

Which statement about R1 is true?

OSPF redistributes RIP routes only if they have a tag of one.

RIP learned routes are distributed to OSPF with a tag value of one.

R1 adds one to the metric for RIP learned routes before redistributing to OSPF.

RIP routes are redistributed to OSPF without any changes.

Question 3

Refer to the exhibit.
300-410 dumps exhibit

Users report that IP addresses cannot be acquired from the DHCP server. The DHCP
server is configured as shown. About 300 total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day. Which action fixes the issue within the current resources?

Modify the subnet mask to the network 192.168.1.0 255.255.254.0 command in the DHCP pool

Configure the DHCP lease time to a smaller value

Configure the DHCP lease time to a bigger value

Add the network 192.168.2.0 255.255.255.0 command to the DHCP pool

Question 4

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

router ospfv3 1address-family ipv4

Router(config-router)#ospfv3 1 ipv4 area 0

Router(config-if)#ospfv3 1 ipv4 area 0

router ospfv3 1address-family ipv4 unicast

Question 5

Refer to the exhibit.
300-410 dumps exhibit

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the
configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

Use an extended access list instead of a standard access list.

Change sequence 10 in the route-map command from permit to deny.

Use a prefix list instead of an access list in the route map.

Add this statement to the route map: route-map RM-OSPF-DL deny 20.

Question 6

Which command displays the IP routing table information that is associated with VRF-Lite?

show ip vrf

show ip route vrf

show run vrf

show ip protocols vrf

Question 7

Refer to the exhibit.
300-410 dumps exhibit

Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to R2?
300-410 dumps exhibit

Option A

Option B

Option C

Option D

Question 8

Which list defines the contents of an MPLS label?

20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL

32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL

20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit

32-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit

Question 9

Refer to the exhibit.
300-410 dumps exhibit

Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?

policy-map SHAPE_BGP

policy-map LIMIT_BGP

policy-map POLICE_BGP

policy-map COPP

Question 10

Refer to the exhibit.
300-410 dumps exhibit

Why is user authentication being rejected?

The TACACS+ server expects “user”, but the NT client sends “domain/user”.

The TACACS+ server refuses the user because the user is set up for CHAP.

The TACACS+ server is down, and the user is in the local database.

The TACACS+ server is down, and the user is not in the local database.

Question 11

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.
300-410 dumps exhibit

Solution:
300-410 dumps exhibit

Does this meet the goal?

Yes

Question 12

Which statement about route distinguishers in an MPLS network is true?

Route distinguishers allow multiple instances of a routing table to coexist within the edge router.

Route distinguishers are used for label bindings.

Route distinguishers make a unique VPNv4 address across the MPLS network.

Route distinguishers define which prefixes are imported and exported on the edge router.

Question 13

Refer to the exhibit.
300-410 dumps exhibit

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot
reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?

Set the administrative distance 100 under the RIP process on R2.

Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.

Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.

Redistribute the directly connected interfaces on R2.

Question 14

Which configuration enabled the VRF that is labeled “Inet” on FastEthernet0/0?

R1(config)# ip vrf InetR1(config-vrf)#ip vrf FastEthernet0/0

R1(config)#ip vrf Inet FastEthernet0/0

R1(config)# ip vrf InetR1(config-vrf)#interface FastEthernet0/0 R1(config-if)#ip vrf forwarding Inet

R1(config)#router ospf 1 vrf InetR1(config-router)#ip vrf forwarding FastEthernet0/0

Question 15

Which transport layer protocol is used to form LDP sessions?

UDP

SCTP

TCP

RDP

Question 16

Refer to the exhibit.
300-410 dumps exhibit

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?
300-410 dumps exhibit

Option A

Option B

Option C

Option D

Question 17

Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.
300-410 dumps exhibit

Solution:
300-410 dumps exhibit

Does this meet the goal?

Yes

Question 18

Drag and drop the DHCP messages from the left onto the correct uses on the right.
300-410 dumps exhibit

Solution:
300-410 dumps exhibit

Does this meet the goal?

Yes

Question 19

Drag and drop the OSPF adjacency states from the left onto the correct descriptions on the right.
300-410 dumps exhibit

Solution:
300-410 dumps exhibit

Does this meet the goal?

Yes

Question 20

Refer to the exhibit.
300-410 dumps exhibit

An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed. What is the reason for this issue?

By default, only internal routes and external type 1 routes are redistributed into BGP

Only classful networks are redistributed from OSPF to BGP

BGP convergence is slow, so the route will eventually be present in the BGP table

By default, only internal OSPF routes are redistributed into BGP

Question 21

While troubleshooting connectivity issues to a router, these details are noticed:
300-410 dumps exhibit

Standard pings to all router interfaces, including loopbacks, are successful.
300-410 dumps exhibit

Data traffic is unaffected.
300-410 dumps exhibit

SNMP connectivity is intermittent.
300-410 dumps exhibit

SSH is either slow or disconnects frequently.
Which command must be configured first to troubleshoot this issue?

show policy-map control-plane

show policy-map

show interface | inc drop

show ip route

Question 22

Refer to the exhibits.
300-410 dumps exhibit

Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two commands are missing? (Choose two.)

The ip nhrp redirect command is missing on the spoke routers.

The ip nhrp shortcut command is missing on the spoke routers.

The ip nhrp redirect command is missing on the hub router.

The ip nhrp shortcut command is missing on the hub router.

The ip nhrp map command is missing on the hub router.

Question 23

An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)

Copy the file to the destination router with the copy tftp: flash: command

Enable the TFTP server on the source router with the tftp-server flash: <filename> command

TFTP is not supported in recent IOS versions, so an alternative method must be used

Configure a user on the source router with the username tftp password tftp command

Configure the TFTP authentication on the source router with the tftp-server authentication local command

Question 24

Refer to the exhibit.
300-410 dumps exhibit

An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+. Which action produces the desired configuration?

Add the aaa authentication login default none command to the global configuration.

Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.

Add the aaa authentication login default group tacacs+ local-case command to the global configuration.

Add the login authentication Console command to the line configuration

Question 25

Refer to the exhibit.
300-410 dumps exhibit

During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?

permit tcp port 443

permit udp port 465

permit tcp port 465

permit tcp port 22

Page: 1 / 4

Total 58 questions Full Exam Access