11 June, 2022

Top Tips Of Replace 350-801 Testing Software

Examcollection offers free demo for 350-801 exam. "Implementing and Operating Cisco Collaboration Core Technologies", also known as 350-801 exam, is a Cisco Certification. This set of posts, Passing the Cisco 350-801 exam, will help you answer those questions. The 350-801 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 350-801 exams and revised by experts!

Free demo questions for Cisco 350-801 Exam Dumps Below:

Page: 1 / 0

Total 0 questions Full Exam Access

Question 1

Refer to the exhibit.
350-801 dumps exhibit

What is a possible cause of the PRI issue?

The cable is unplugged.

The clock source is incorrect.

The controller shut down.

The framing is configured incorrectly.

Question 2

Which configuration tells a switch part to send Cisco Discovery Protocol packets that configure an attached Cisco IP phone to trust tagged traffic that is received from a device that is connected to the access port on the Cisco IP phone?

Router# configure terminalRouter(config)# interface gigabitethernet 5/1 Router(config-if)# platform qos trust extend

Router# configure terminalRouter(config)# interface gigabitethernet 5/1 Router(config-if)# platform qos trust extend cos 3

Router# configure terminalRouter(config)# interface gigabitethernet 5/1 Router(config-if)# platform qos trust extend cos 5

Router# configure terminalRouter(config)# interface gigabitethernet 5/1 Router(config-if)# platform qos extend trust

Question 3

Which action is required if an engineer wants to have Cisco Unified Communications Manager control the configuration for an MGCP gateway?

Apply the ccm-manager configuration commands to the gateway.

Upload the custom configuration in the TFTP server in Cisco Unified CM.

From Cisco Unified CM > Device > Gateway > Add gateway, check the auto-configuration check box.

Configure the Cisco Unified CM's IP in voice service VoIP.

Question 4

Which call flow matches traffic from a Mobile and Remote Access registered endpoint to central call control?

Endpoint > Expressway-E > Expressway-C > Cisco Unified CM

Endpoint > Expressway-E > Cisco Unified CM

Endpoint > Expressway-C > Cisco Unified CM

Endpoint > Expressway-C > Expressway-E > Cisco Unified CM

Question 5

What causes poor voice quality and video pixelization in a video call?

The QoS is configured incorrectly.

A firewall is blocking the RTP ports.

Cisco Unified Communications Manager is configured to use G.711 instead of G.729.

1 Gbps network ports are used instead of 100 Mbps network ports.

Question 6

Which endpoint feature is supported using Mobile and Remote Access through Cisco Expressway?

SRST

SSO

H.323 registration proxy to Cisco Unified Communications Manager

MGCP gateway registration

Question 7

Which two functionalities does Cisco Expressway provide in the Cisco Collaboration architecture? (Choose two.)

Survivable Remote Site Telephony functionality

customer interaction management services

secure firewall and NAT traversal for mobile or remote Cisco Jabber and TelePresence Video endpoints

MGCP gateway registration

Secure business-to-business communications

Question 8

A user reports transfer failure from an IP phone for calls received from a PSTN to another PSTN number. What is a reason for these failures?

The IP phone is configured with the wrong region.

The incoming calling search space of the SIP trunk does not include the partition of the line in the IP phone.

The service parameter related to Offnet to Offnet Call Transfer is set to TRUE.

The gateway is configured with the wrong device pool.

Question 9

A remote office has a less-than-optimal WAN connection and experiences packet loss, delay, and jitter. Which VoIP codec should be used in this situation?

G.711ulaw

iLBC

G.722.1

G.729A

Question 10

Which Cisco Unified Communications Manager service parameter should be enabled disconnect a multiparty call when the call initiator hangs up?

Drop Ad Hoc Conference

H.225 Black Setup Destination

Block OffNet To OffNet Transfer

Enterprise Feature Access Code for Conference

Question 11

An engineer wants to manually deploy a Cisco Webex DX80 video endpoint to an end user. Which type of provisioning can be configured on the endpoint?

CUBE

CMS

CUCM

Edge

Question 12

Which issue can occur if QoS is not deployed on a Cisco Collaboration architecture across the WAN?

403 Forbidden errors on SIP calls

excessive jitter

unexpected shut-down on Cisco Unified Communications Manager

packet fragmentation

Question 13

An engineer configures local route group to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?

CSS

route pattern

device pool

route list

Question 14

A user forwards a corporate number to an international number. What are two methods to prevent this forwarded call? (Choose two.)

Set the Call Classification to OnNet for the international route pattern.

Block international dial patterns in the SIP trunk CSS.

Configure a Forced Authorization Code on the international route pattern.

Set Call Forward All CSS to restrict international dial patterns.

Check Route Next Hop By Calling Party Number on the international route pattern.

Question 15

An engineer with ID012345678 must build an international dial plan in Cisco Unified Communications Manager. Which action should be taken when building a variable-length route pattern?

reduce the T302 timer to less than 4 seconds

configure single route pattern for international calls

create a second route pattern followed by the # wildcard

set up all international route patterns to 0.!

Question 16

Which action prevents toll fraud in Cisco Unified Communications Manager?

Implement toll fraud restriction in the Cisco IOS router.

Implement route patterns in Cisco Unified CM.

Allow off-net to off-net transfers.

Configure ad hoc conference restriction.

Question 17

What is the element of Cisco Collaboration infrastructure that allows Jabber clients outside of the network to register in Cisco Unified Communications Manager and use its resources?

Cisco IM and Presence node

Cisco Unified Border Element

Cisco Expressway

Cisco Prime Collaboration Provisioning server

Question 18

On which protocol and port combination does Cisco Prime Collaboration receive notifications (Traps and InformRequests) from several network devices in the Collaboration infrastructure for which it has requested notifications?

UDP 162

TCP 80

UDP 161

TCP 161

Question 19

Which protocol does Cisco Prime Collaboration Assurance use to poll the health status of different systems in the Collaboration environment?

SIP

SNMP

SCCP

SMTP

Page: 1 / 0

Total 0 questions Full Exam Access